 |
 |
 |
|
|
|
[Sponsors] | ||||
November 2, 2002, 06:56
|
Fan not working
|
#1 |
|
Guest
Posts: n/a
|
Now here! i have set a fan BC in gambit on a face and meshed geometry ie exported to flluent ok. Read that msh file is ok. check is ok in fluent 6.0.12. When i go to DEFINE>Boundary Conditions>fan Opens panel for Fan but there is: Under Pressure Jump Specifications: ...Zone Average Direction X: -1.#IND Y: -1.#IND Z: -1.#IND And this I am unable to change. Iterating unsteady giving me, FLoating point error invalid number, even after 1st iteration. What do you do for me about this? Thanks.
|
|
|
||
|
November 6, 2002, 03:42
|
Re: Fan not working
|
#2 |
|
Guest
Posts: n/a
|
Hi... Zahid I cant able to get you problem can you explain it clearly.
|
|
|
|
||
|
November 6, 2002, 15:29
|
Re: Fan not working
|
#3 |
|
Guest
Posts: n/a
|
When i go to DEFINE>Boundary Conditions>fan Opens panel for Fan but there is: Under Pressure Jump Specifications: ...Zone Average Direction X: -1.#IND Y: -1.#IND Z: -1.#IND And this I am unable to change.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Modeling a Fan by the Multiple reference frame (MRF) method in CFX. | saisanthoshm88 | CFX | 11 | February 17, 2021 11:30 |
| Jet fan and Tunnel simulation | ahlo7 | CFX | 9 | November 13, 2019 04:54 |
| Simulation of Axial Fan Flow using A Momentum Source Subdomain | Liam | CFX | 28 | July 16, 2013 08:24 |
| Proper BCs for internal fan | serezhkin | CFX | 3 | July 28, 2010 10:04 |
| Propeller Fan Curve Simulation | Teng_YJ | FLUENT | 2 | February 16, 2009 19:37 |
Linear Mode
