|
[Sponsors] |
density update by UDF in non-premixed combustion |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 18, 2002, 11:49 |
density update by UDF in non-premixed combustion
|
#1 |
Guest
Posts: n/a
|
Dear all,
I am currently using FLUENT 6 under linux. I am trying to find what DEFINE_**** can update my own UDF of density in non-premixed combusiton model. In the material pannal, I can not change the density... the manual says.. density is only a function of temperature.. but the updated density is not. Could you tell me how to feedback the new density field to FLUENT combusiton model ? ( the new density can take the calculated values from FLUENT, such as velocities, turbulent energy, species, mixture fraction and variances.... etc.) many thanks |
|
November 24, 2002, 01:59 |
Re: density update by UDF in non-premixed combusti
|
#2 |
Guest
Posts: n/a
|
Dear sir I have a problem with this title. If it's possible for you please send me your received responses. Very thanks for your attention to my request. With the best regards. Mahdi saniee nezhad
|
|
December 8, 2002, 21:37 |
Re: density update by UDF in non-premixed combusti
|
#3 |
Guest
Posts: n/a
|
I am not sure this is correct way or not. If you can make out file for density of domain where you are willing to know, you can put it on your UDF for density.
UDF for density (of course, should be interpreted type) Macro : automatic iteration with initialization Out file : density data calculated by each iteration External program : check Out file and exchange density of your UDF, and run Macro. In my case, of couser I do not consider density, I made above four different file types to optimize calulation, especially temeprature at specific point. External program starts Macro --> run Fluent with initial condition after initialization --> when converged, External file checks "out" file(in my case, temperature of specific point) --> calculate new input at external program (recalculate input power based on temperature of "out" file) --> exchange new input value in Macro or UDF --> run again Macro Sequential iteration gave me final well converged results from 2~3 repeated iteration. Probably, you may need to use this kinds of method. I hope this is helpful to your trouble. Thanks, J.W.Ryu |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
urgent!!! please...about Premixed Combustion | mesinUGM | FLUENT | 6 | March 30, 2012 10:22 |
The problem of UDF in Non premixed combustion model | zhangyuan | Main CFD Forum | 0 | May 25, 2009 10:41 |
Premixed combustion using Fluent 6.2.16 | Rucy | FLUENT | 2 | December 17, 2005 03:14 |
Gravity, UDF Source & Operating Density. HELP ME! | Brian | FLUENT | 0 | November 1, 2005 16:17 |
UDF to change density in species transport | Karthik | FLUENT | 6 | December 8, 2004 19:19 |