|
[Sponsors] |
November 18, 2002, 13:48 |
boundary conditions
|
#1 |
Guest
Posts: n/a
|
hello out there, i have got a problem with the boundary conditions which i define with a profile. the problem is that the massflow is ok but the mass fraction of ch4 is after converging too high (smth about 7 per cent). if anybody has an idea, please write because i am going mad at the moment. Thanks Stefan
|
|
November 18, 2002, 14:17 |
Re: boundary conditions
|
#2 |
Guest
Posts: n/a
|
How do u know it is converged ? Could you describe your prob more? U don't expect the ch4 is 7%, right? How do u know its high?
Nancy |
|
November 19, 2002, 09:19 |
Re: boundary conditions
|
#3 |
Guest
Posts: n/a
|
during the first iterations the massfraction was changing all the time, but after about 30 iterations the massfraction kept constant. this value was about 7 per cent higher then it should be. i am writting the profiles by myself. in the profiles i define the temperature, the velocity and the massfraction. in order to calculate the velocity i am using the face area of the cells. ahh i should also mention that i am using velocity inlet. my mainproblem is that i cannot understand that the massflow is ok and the massfraction not. i am quite sure that the massfraction in the profile is ok. Thanks for the quick response Bye Stefan
|
|
November 24, 2002, 00:57 |
Re: boundary conditions
|
#4 |
Guest
Posts: n/a
|
Dear sir I have a problem with this title. If it's possible for you please send me your received responses. Very thanks for your attention to my request. With the best regards. Mahdi saniee nezhad
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
OpenFOAM Variable Velocity Boundary Conditions | NickolasPl | OpenFOAM Programming & Development | 2 | May 19, 2011 05:37 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |