 |
 |
 |
|
|
|
[Sponsors] | ||||
December 24, 2002, 12:57
|
Meshing volumes for different mesh size
|
#1 |
|
Guest
Posts: n/a
|
Hi! i have a 20 mm pipe connected to 300 mm diameter tank. due to difference in volumes, i want to mesh both fr different mesh size. CAN SOME ONE HELP ME HOW TO DO THIS. Regards
|
|
|
||
|
December 25, 2002, 01:08
|
Re: Meshing volumes for different mesh size
|
#2 |
|
Guest
Posts: n/a
|
Hi, You could create different zone and then mesh in different size. Brandy
|
|
|
|
||
|
December 25, 2002, 15:31
|
Re: Meshing volumes for different mesh size
|
#3 |
|
Guest
Posts: n/a
|
Thanx Brandy fr ur reply. but i could not get clearly how to resolve the problem. can u elaborate more. i am a new fluent user. regards
|
|
|
|
||
|
December 28, 2002, 01:42
|
Re: Meshing volumes for different mesh size
|
#4 |
|
Guest
Posts: n/a
|
mesh the line,then the volume,you can get it!
|
|
|
|
||
|
January 22, 2003, 20:11
|
Re: Meshing volumes for different mesh size
|
#5 |
|
Guest
Posts: n/a
|
Meaning that I only need to mesh the edge for the model? (without considering face mesh and etc).What about region refinement of the model? Can I specify different size of mesh in 1 volume? If it is possible , how do I go about doing that? I'm a new user of Fluent.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| unstructure mesh size control near to wall using gambit | lalit kumar | FLUENT | 4 | July 6, 2010 15:13 |
| Gambit Unstructed (Tet) Mesh - size control | newbie | FLUENT | 3 | August 26, 2008 11:38 |
| How to decide the mesh size? | echo | Siemens | 1 | May 23, 2006 05:34 |
| Gambit: mesh size to small??? | Ralf Schmidt | FLUENT | 1 | January 28, 2006 01:26 |
Linear Mode
