HAllo everybody

I have just recently changed to Fluent 6 from fluent 5 (and the new gambit versions).

I tried to make a simple 2D model of a duct from buttom up principle (vertices - lines and then a surface).

Then I apply in- and outlet to appropriate edges and makes a mesh. Then I would like to export it to Fluent (mesh). However I cannot do that. I am told that a unspecified thing is created and then this cannot be handle by Fluent 6. I have done the same thing in Fluent 5 and the old Gambit without any problem.

Please help me

Bo

Problwem solved - I just had to open my eyes.... It must be because it is Friday afternoon