Error message on Cooper scheme mesh

January 20, 2003, 03:08

Me and my famous workmate are trying to mesh a 3d volume with a Cooper scheme.

We set the edge mesh and then volume mesh.

BUT

ERROR: A mismatch of previously meshed intervals between outer and inner surfaces exists on volume v_volume.24 when using meshing scheme of Cooper.

Is it a problem of mesh surface inside the concerned volume or is it in relation with other volume around.

Notice that sometimes we got 2 real faces for one. The first one is for the volume on a top and the second one is for the volume at the bottom. Those are real and have exactly the same position but they dont have the same higher topology.

January 20, 2003, 05:56

You are trying to cooper but the mapped faces along which you want to project are different. They have to have same number of intervals. Try meshing them all individually before you cooper and make sure they match.

January 20, 2003, 03:08	Error message on Cooper scheme mesh	#1
Mnu & Luc Guest Posts: n/a	Me and my famous workmate are trying to mesh a 3d volume with a Cooper scheme. We set the edge mesh and then volume mesh. BUT ERROR: A mismatch of previously meshed intervals between outer and inner surfaces exists on volume v_volume.24 when using meshing scheme of Cooper. Is it a problem of mesh surface inside the concerned volume or is it in relation with other volume around. Notice that sometimes we got 2 real faces for one. The first one is for the volume on a top and the second one is for the volume at the bottom. Those are real and have exactly the same position but they dont have the same higher topology.

January 20, 2003, 05:56	Re: Error message on Cooper scheme mesh	#2
Erwin Guest Posts: n/a	You are trying to cooper but the mapped faces along which you want to project are different. They have to have same number of intervals. Try meshing them all individually before you cooper and make sure they match.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10
dynamic mesh - structured or cooper mesh	Manoj Kumar	FLUENT	2	November 11, 2005 01:18