Home > Forums > Software User Forums > ANSYS > FLUENT

How can I change the hydraulic diameter

Mark Forums Read

Reply

Search this Thread

January 23, 2003, 08:31	How can I change the hydraulic diameter	#1
felh Guest Posts: n/a	I am modelling the laminar flow in the curved duct of rectangular cross section (a x b). How can I change the hydraulic diameter in the system of equation by the channel width (a). Many thanks

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Hydraulic Diameter - Series of Holes	Jop	FLUENT	6	January 14, 2019 10:41
equivalent diameter vs hydraulic diameter	swamysrikanth	FLUENT	1	October 12, 2013 02:18
[GAMBIT] hydraulic diameter?	Zweeper	ANSYS Meshing & Geometry	6	January 4, 2010 01:44
hydraulic diameter in 2d	ahsan	FLUENT	2	August 28, 2009 16:22
Importance of Hydraulic Diameter Value for Compressible Flow	RyGuy	FLUENT	0	August 6, 2009 11:58

All times are GMT -4. The time now is 18:28.