|
[Sponsors] |
March 10, 2003, 07:20 |
tURBULENT vISCOSITY
|
#1 |
Guest
Posts: n/a
|
turbulent viscosity limited to 2345 CELLS. wHAT IT MEANS? wILL IT EFFECT THE SOLUTION?
|
|
March 10, 2003, 07:39 |
Re: tURBULENT vISCOSITY
|
#2 |
Guest
Posts: n/a
|
Try searching for your subject in the list. It is a commeny posed question in this forum.
|
|
March 10, 2003, 14:21 |
Re: refine grid
|
#3 |
Guest
Posts: n/a
|
Hi Zahid
It means that you have some elements with large volume, therefore I suggest that you plot a turbulent viscosity ratio contour and then change the auto range to a value between 10000 and 50000. In this way you will see where are the elements that are touching the turbulent viscosity ratio. Once you identifiy the cells, refine these elements. In this way the velocity diferences between two adjacent cells is not to high to give you the warning turbulent viscosity limit 1e05. Regards Alex Munoz |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reversed flow at pressure inlet and turbulent viscosity is limited.... | cfdiscool | FLUENT | 10 | June 10, 2015 06:15 |
k-epsilon problem: non-physical turbulent viscosity production in coaxial free-jet | Felipeb | Main CFD Forum | 1 | July 26, 2010 17:02 |
Turbulent viscosity and shear rate | shib | FLUENT | 0 | June 22, 2010 12:44 |
setting value of turbulent intensity and turbulent viscosity ratio in wind tunnel | nuimlabib | Main CFD Forum | 0 | August 4, 2009 00:05 |
Problem of Turbulent Viscosity Ratio Limited | David Yang | FLUENT | 3 | June 3, 2002 06:13 |