Hi! I have a problem with meshing a lake. I had build the geometry of the lake using the option in Gambit 2.0.4 "Create real skin surface face" because I had some edges imported from AutoCad2000. Then when I had faces I changed them into one geometry using the "Stitch faces". I healed new geometry and check volume.It was ok. But I should tell that all faces were very long but very thin. Then I mesh faces using the Tri/Pave, interval size 30. I check all faces and they are ok - skewness. If not I mesh them again. But unfortunatly I can't mesh the volume. I had got information about error. Please if you meet with that problem, please give me a know. Best regards. Paulina

can u tell what error message was that,

arjun