CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Dynamic mesh

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 17, 2003, 05:41
Default Dynamic mesh
  #1
nicolas
Guest
 
Posts: n/a
Hello

The subject is a study 2d with a cylinder and the 2 valves. The motion piston is good with dynamic layering zone to represent the mesh regions swept out the moving surfaces or edges in 2D. The motion intake valve is correct until 90° of crank angle, the valve goes down in the cylinder and after 90°, the intake valve goes up and the problem begin. The remeshing parameters are not taken in account at the interface between valve and remeshing chamber and negative volume appear because a node goes up faster than an other one. The time step does change anything.

What is the problem ?
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Dynamic Mesh on Pintle type injector. herntan FLUENT 16 September 4, 2020 09:27
pls help. mesh collapsed with dynamic mesh. wlt_1985 FLUENT 2 May 7, 2020 11:42
Incylinder dynamic mesh with volumetric reaction mas FLUENT 4 May 3, 2012 11:22
dynamic mesh on a hexa grid Manoj Kumar FLUENT 0 August 21, 2007 08:41
Dynamic mesh + grid adapt = Crash! (Files included BillH FLUENT 4 July 24, 2007 16:31


All times are GMT -4. The time now is 18:16.