CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Manipulating flow speed at wall

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 17, 2003, 19:32
Default Manipulating flow speed at wall
  #1
Salman
Guest
 
Posts: n/a
The fluid velocity at wall use to be 0 for continuum case. But if we want to simulate rarefied gas then we need to specify slip velocity at the wall. One option available is to activate Shear Stress option in wall boundary condition. This way we can get non-zero velocity at wall, but the problem is that this slip velocity is calculated on the basis of the value of Shear Stress provided.

Is there any way to give non-zero velocity at wall using some velocity macro?

Did anybody try this earlier?
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[Commercial meshers] Fluent3DMeshToFoam simvun OpenFOAM Meshing & Mesh Conversion 50 January 19, 2020 16:33
Water subcooled boiling Attesz CFX 7 January 5, 2013 04:32
Velocity at wall in an internal flow rsmartins CFX 3 July 16, 2011 07:58
Can OpenFOAM generate flow at the speed of light? Michel_sharp OpenFOAM 6 October 24, 2009 05:09
low speed compressible two phase flow?? cat CFX 0 November 15, 2005 08:59


All times are GMT -4. The time now is 08:32.