|
[Sponsors] |
May 2, 2003, 04:54 |
Transient using target mass flow
|
#1 |
Guest
Posts: n/a
|
Hello:
In my project, only pressure in inlet and mass flow rate in outlet is known. Both steady and transient calculation are needed to perform. For steady analysis, I can use target mass flow rate in outlet and get converged solution. However, how can I perform transient one using TMR? By UDF or profile? Any suggestion is appreciated. Thanks in advance. Z.T. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Target Mass Flow Rate | Nitin | FLUENT | 9 | June 17, 2017 10:30 |
Running dieselFoam error | adorean | OpenFOAM Running, Solving & CFD | 119 | February 1, 2016 14:41 |
Boundary condition for exhaut flow with imposed mass flow | stephane | FLUENT | 1 | November 24, 2011 02:04 |
udf for transient mass flow rate inlet | mdzubairmanipal@gmail.com | Fluent UDF and Scheme Programming | 0 | February 22, 2011 02:51 |
Mass flow imbalance in transient state | Ton | CFX | 3 | June 2, 2009 01:05 |