 |
 |
 |
|
|
|
[Sponsors] | ||||
May 17, 2003, 14:47
|
smallest possible interval size GAMBIT
|
#1 |
|
Guest
Posts: n/a
|
How much smaller interval size can be chosen in GAMBIT?
When I tray 3e-07 as an interval size I get error message: "interval size can not be smaller than geometry tolerance". Is the geometry tolerance is something can be adjusted? I lookforward comment on this error message. |
|
|
||
|
May 19, 2003, 22:43
|
Re: smallest possible interval size GAMBIT
|
#2 |
|
Guest
Posts: n/a
|
I don't know either. But usually I scale up small geometry size when I draw a geometry in Gambit. For example, 1mm is scale up to 1m. The scaled up mesh can be scale down by Fluent.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| finding the size of smallest cell | cfdiscool | FLUENT | 6 | June 18, 2013 06:20 |
| critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 04:01 |
| [Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 16:45 |
| Gambit Size functions issue | jon | FLUENT | 1 | December 13, 2006 11:39 |
| Size Functions in Gambit | chanchala | FLUENT | 3 | December 9, 2003 09:50 |
Linear Mode
