Fluent tutorial

June 17, 2003, 10:13

Does anybody have links for good fluent tutorial. prasat

June 17, 2003, 10:18

http://che.cycu.edu.tw/mphl/Courses/...uent/Fluent50/

For example. But try Google there are a lot of tuto..

June 18, 2003, 00:44

goami · June 20, 2003, 06:50

Dear sir iam using CFD to model steam ejector, i did more than fifty cases but there is no convergence up to now. anyway, i am asking about 1- how do use multigrid in the ejector 2- the working fluid is steam, and i want to use species, for the inlet and outlet, could you please tell me how to do species for the same working fluid, just small difference in the properties at inlet 1 from evaporator and at inlet 2 from steam generator. 3- how to do pressure gradient after some iteration. and also which the best turbulent sitting can be used for ejector thank you very much yours sincerely Ablwaifa

goami · December 31, 2011, 13:46

bro i am working in the same kind of problem but couldn't get convergence and don't know how to interpret pressure ratio in fluent......,,, i am giving the mass fractions but couldn't figure out in what way code is taking up.....

June 17, 2003, 10:13	Fluent tutorial	#1
prasat Guest Posts: n/a	Does anybody have links for good fluent tutorial. prasat

June 17, 2003, 10:18	Re: Fluent tutorial	#2
rosco Guest Posts: n/a	http://che.cycu.edu.tw/mphl/Courses/...uent/Fluent50/ For example. But try Google there are a lot of tuto..

June 18, 2003, 00:44	Re: Fluent tutorial	#3
jiaruixuan Guest Posts: n/a

June 20, 2003, 06:50	ejector modelling	#4
Ablwaifa Ali Guest Posts: n/a	Dear sir iam using CFD to model steam ejector, i did more than fifty cases but there is no convergence up to now. anyway, i am asking about 1- how do use multigrid in the ejector 2- the working fluid is steam, and i want to use species, for the inlet and outlet, could you please tell me how to do species for the same working fluid, just small difference in the properties at inlet 1 from evaporator and at inlet 2 from steam generator. 3- how to do pressure gradient after some iteration. and also which the best turbulent sitting can be used for ejector thank you very much yours sincerely Ablwaifa goami likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
fluent tutorial	rayy	FLUENT	16	September 25, 2012 10:45
few quesions on ANSYS ICEMCFD and FLUENT	Prakash.Paudel	ANSYS	0	August 12, 2010 12:07
IC engine simulation tutorial by FLUENT	yash	Main CFD Forum	1	April 21, 2009 05:05
Case in Fluent Tutorial 1	Lam	FLUENT	0	August 24, 2004 11:25
SOS tutorial fluent 5.3	kostas156	FLUENT	1	November 19, 2002 02:14

December 31, 2011, 13:46		#5
goami New Member goami Join Date: Dec 2011 Posts: 6 Rep Power: 14	bro i am working in the same kind of problem but couldn't get convergence and don't know how to interpret pressure ratio in fluent......,,, i am giving the mass fractions but couldn't figure out in what way code is taking up.....