 |
 |
 |
|
|
|
[Sponsors] | ||||
June 21, 2003, 02:03
|
3d Boundary Layer
|
#1 |
|
Guest
Posts: n/a
|
hello fluent users, actually i want to do a cfd for a car and i want to attach a boundary layer as the card is surrounded by the fluid domain and in gambit i was unable to attach the boundary layer pependicular to the faces in 3d some one please help me in this matter
|
|
|
||
|
June 22, 2003, 23:37
|
Re: 3d Boundary Layer
|
#2 |
|
Guest
Posts: n/a
|
What do you mean unable? Click shift+middle mouse botton, you can change the direction of boundary layer. If you are using tet mesh, enable internal continuity option.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] Default Faces on Boundary Layer | axel | OpenFOAM Meshing & Mesh Conversion | 8 | February 17, 2011 07:47 |
| Boundary Layer Question | scottneh | STAR-CCM+ | 3 | September 30, 2010 14:21 |
| Adapt mesh without modifying boundary layer cells? | Freeman | FLUENT | 0 | February 22, 2009 14:11 |
| 3D Boundary Layer | Mario | FLUENT | 0 | February 17, 2009 03:40 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
