about Gambit 2.04 and STAR-CD -- CFD Online Discussion Forums

June 24, 2003, 01:19	about Gambit 2.04 and STAR-CD	#1
Jack Guest Posts: n/a	Hi, When i using Gambit, the err message prompt: { Cannot open connect stream. TRANS(SocketINETGetAddr): tnamebysocket() failed TRANS(SocketINETConnect): TRANS(SocketINETGetAddr) () failed TRANS(Open): transport open failed for tcp/LOCALPC:0 Unable to open display } Only after I using Star-CD, the err occur.and Gambit never start again. this means that I should install the Exceed & 3D again? or only re-config the Exceed? a'cai Thx!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
Equivalent of Gambit neutral file in star ccm	pradeap	STAR-CCM+	3	July 2, 2010 07:36
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
meshing under star cd or gambit?	juv971	Main CFD Forum	0	February 3, 2010 10:22
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 02:17.