|
[Sponsors] |
July 2, 2003, 22:55 |
volume meshing
|
#1 |
Guest
Posts: n/a
|
hello friends..i still have a problem on volume meshing.i draw a small aircraft model and the model will put in the wind tunnel.so i draw the half model of the aircraft, and then create a brick which will be assume as a wind tunnel.the dimension of wind tunnle is (1*1*2.5)M.after creating this two volume, i subtract it in to 1 volume.the problem appeared when i mesh the volume,it said that check the skewness and maybe the face mesh is too big for a small gap..then i shift the position on one part of the aircraft, then, the volume mesh is success..the problem comes again when i try to export to fluent.the error is sound like this: A DEFAULT (UNSPECIFIED) BOUNDARY WAS CREATED ERROR:AN INCORRECT MESH HAS BEEN STORED.CHECK MESH QUALITY BEFORE EXPORT. VOLUME 3 HAS INCORRECT MESH AT FACE FACE63... pls advise
|
|
July 3, 2003, 02:25 |
Re: volume meshing
|
#2 |
Guest
Posts: n/a
|
Hi!
It may be helpful if you would split your domain into more than one volume. Instead of substracting the volumes make more smaller volumes with create edge - form face - form volume... Good luck Mateus |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'Tetrahedral meshing has failed for volume...' | Murat | FLUENT | 5 | February 19, 2011 05:22 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
Meshing volume | F.A. | FLUENT | 3 | December 12, 2005 02:31 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |
Patran Volume Meshing | Deb | CFX | 19 | April 17, 2003 11:56 |