 |
 |
 |
|
|
|
[Sponsors] | ||||
3D multiphase flow on complex structure-liquid droplet splash |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 16, 2016, 22:30
|
3D multiphase flow on complex structure-liquid droplet splash
|
#1 |
|
New Member
J. David
Join Date: May 2013
Posts: 10
Rep Power: 12  |
Hi everyone:
I am modeling multiphase flow(nearly free surface flow) in the packing.However, I found that, for the 3D simulation,there are some liquid droplets represent in the gas phase which may be not right. My grid is created by the cooper method, and the quality is not so bad. I also changes the value of valume fraction cutoff,but it doesn't work.Anyone has suggestions? Last edited by jc2006; May 17, 2016 at 01:36. |
|
|
|
|
|
May 17, 2016, 20:34
|
|
#2 |
|
New Member
J. David
Join Date: May 2013
Posts: 10
Rep Power: 12 |
I have find the problem
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Modeling Liquid Liquid droplet flow | Mircro_fluidics_ | STAR-CCM+ | 7 | November 14, 2017 02:51 |
| Calculating mass flow rate at multiphase flows | Kuslo187 | OpenFOAM Post-Processing | 1 | August 21, 2015 18:11 |
| Multiphase flow and convergence issues | Erik | FLUENT | 1 | July 13, 2009 17:08 |
| About the multiphase flow | Xue | FLUENT | 4 | September 19, 2008 13:05 |
| Flow visualization vs. Calculated flow patterns | Francisco Saldarriaga | Main CFD Forum | 1 | August 2, 1999 23:18 |
Linear Mode
