|
[Sponsors] |
How to get the intepolated value of any point? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 19, 2003, 12:29 |
How to get the intepolated value of any point?
|
#1 |
Guest
Posts: n/a
|
I want to write a UDF for DPM because the Random Walk model of FLUENT gives nonphysical result in inhomogeneous turbulence field. Then I need the intepolated values of velocities, Reynolds stresses, kinetic engergy, dissipation rate, at the current particle position.
Is there a Macro to do this? or can I know that which head file should I refer to? Thanks a lot! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
Problem with UDF compiling for kTkLW model | Wantami | FLUENT | 0 | July 18, 2011 05:11 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |