 |
 |
 |
|
|
|
[Sponsors] | ||||
July 21, 2003, 03:53
|
Time Estimation
|
#1 |
|
Guest
Posts: n/a
|
I am running a 3d model of a horizontal three phase separator using VOF model. the lenghth of the separator is 5.8 m and the diameter 1.6 m. Can please someone tell me roughly how many hours I should wait to get a gonverged solution. Or Better How many DAYS? or Months? Thank you i hope that someone will answer.
|
|
|
||
|
July 21, 2003, 04:12
|
Re: Time Estimation
|
#2 |
|
Guest
Posts: n/a
|
It is difficult to answer to this question because there are a lot of parameters: mesh size, cell type, computer, ...
|
|
|
|
||
|
July 21, 2003, 06:24
|
Re: Time Estimation
|
#3 |
|
Guest
Posts: n/a
|
I just asked for a rough estimation since i am not very familiar with the software.
|
|
|
|
||
|
July 21, 2003, 08:37
|
Re: Time Estimation
|
#4 |
|
Guest
Posts: n/a
|
At least one week , I think.
|
|
|
|
||
|
July 21, 2003, 08:47
|
Re: Time Estimation
|
#5 |
|
Guest
Posts: n/a
|
thanx kim, i am already running this for 2 days and i didnt know that it will take that long. bye bye
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Time step size and max iterations per time step | pUl| | FLUENT | 33 | October 23, 2020 22:50 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
| Hydrostatic Pressure and Gravity | miliante | OpenFOAM Running, Solving & CFD | 132 | October 7, 2012 22:50 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Linear Mode
