|
[Sponsors] |
August 27, 2003, 15:13 |
GAMBIT BOUNDARY LAYER
|
#1 |
Guest
Posts: n/a
|
I am using the boundary layer in Gambit to coarsen the grid outside my area of interest. The problem is i get some small zig zag type patterns in the layer. It follows a uniform pattern and then there will be a line through the pattern. What is the problem? Thanks
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A question on "Specifying Boundary Layer Deformation Smoothing" | didiean | FLUENT | 2 | January 16, 2012 22:39 |
Gambit boundary layer | pixie | Main CFD Forum | 1 | September 30, 2009 13:22 |
GAMBIT problem with 3D Boundary Layer when meshing | Anthony Haroutunian | FLUENT | 2 | March 26, 2008 03:02 |
How to use boundary layer option in gambit | san | FLUENT | 0 | May 5, 2006 01:41 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |