|
[Sponsors] |
September 22, 2003, 11:12 |
Mesh around a 3D airfoil
|
#1 |
Guest
Posts: n/a
|
Hello,
I have to create the mesh around a 3d swept wing. I need it to be structured. I have tryed so many times that I have no more ideas to make it. Any suggestions or web address where I could have some help? I have already made it with gambit for a classical wing. It was ok... Thanks Pat |
|
September 25, 2003, 05:07 |
Re: Mesh around a 3D airfoil
|
#2 |
Guest
Posts: n/a
|
Break up the area around the airfoil into seperate volumes. You may also need to use the cooper scheme.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
getting airfoil surface to be recongized for tri mesh | josip76 | ANSYS Meshing & Geometry | 4 | June 9, 2011 22:48 |
[ICEM] Can’t get 2D Blayer in hex mesh to be accurate O-block around airfoil | josip76 | ANSYS Meshing & Geometry | 2 | June 4, 2011 18:03 |
2D airfoil optimisation: the mesh | Marta | Main CFD Forum | 5 | February 6, 2008 01:07 |