 |
 |
 |
|
|
|
[Sponsors] | ||||
March 22, 2018, 06:16
|
2 rotating region problem
|
#1 |
|
Member
Join Date: Sep 2010
Posts: 60
Rep Power: 15  |
Hi all,
Please I have a problem to simulate using Fluent 2 rotors (2 rotating regions) as seen in the attached. The first rotor turn normally but the 2nd change its place (see the figure). Fopr information I defined interface,. Any idea please Last edited by stage81; March 22, 2018 at 07:38. |
|
|
|
|
|
March 22, 2018, 07:39
|
|
#2 |
|
Member
Join Date: Sep 2010
Posts: 60
Rep Power: 15 |
It's ok thanks for all.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How I can introduce my power heat (W) in chtMultiRegionFoam? | aminem | OpenFOAM Pre-Processing | 32 | August 29, 2019 02:23 |
| HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
| Fluent: Flow won't interact with rotating region | TOlsen | FLUENT | 0 | September 26, 2016 11:30 |
| Rotating region of a centr. pump - Counter R wall | Emre | CFX | 0 | September 20, 2007 09:58 |
| [Gmsh] Import gmsh msh to Foam | adorean | OpenFOAM Meshing & Mesh Conversion | 24 | April 27, 2005 08:19 |
Linear Mode
