 |
 |
 |
|
|
|
[Sponsors] | ||||
October 3, 2003, 11:26
|
Modelling Free Surfaces Using Fluent 6
|
#1 |
|
Guest
Posts: n/a
|
I am currently using Fluent 6 to create a 3D model of a free surface representing the interface between water and air. Has anyone already done this? I am using a laminar, time dependant model and the fluids are imiscible. Any suggestions would be gratefully recieved.
|
|
|
||
|
October 3, 2003, 15:11
|
Re: Modelling Free Surfaces Using Fluent 6
|
#2 |
|
Guest
Posts: n/a
|
The most apropriate model for this case is the VOF model, in my opinion. Is that model that you are using?
galeazzo |
|
|
|
||
|
October 4, 2003, 08:41
|
Re: Modelling Free Surfaces Using Fluent 6
|
#3 |
|
Guest
Posts: n/a
|
Hi!
I've done some good simulations (mostly test cases in 2 d) using vof in fluent 6.1.18. Previouslly i've had problems with fluent 6.0... Regards MATEUS |
|
|
|
||
|
October 4, 2003, 09:09
|
Re: Modelling Free Surfaces Using Fluent 6
|
#4 |
|
Guest
Posts: n/a
|
Hi I have some experience to model ski(2D)of an aircraft. I got very bad results with a triangular unstructured mesh, after more time steps. Note that more grid ortogonality at the wall boundries is very important. regards.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plsama modelling in FLUENT | Homayoon | FLUENT | 1 | March 24, 2009 11:24 |
| Modelling a solar simulator in Fluent | Ben | FLUENT | 0 | January 16, 2008 09:43 |
| Modelling a "Rolling Road" in Fluent | Nick | FLUENT | 1 | August 11, 2007 06:43 |
| HELP!:CFD modelling using FLUENT in swimming pool | Tee | Main CFD Forum | 0 | September 7, 2005 20:48 |
| Free surface modelling under CFX 4 | Dahong | CFX | 2 | June 22, 2002 23:07 |
Linear Mode
