|
[Sponsors] |
October 14, 2003, 03:03 |
scale problem
|
#1 |
Guest
Posts: n/a
|
I built two models with one is the 1/25 scale of the other. And their meshes are generated by the same scale. Who can tell me how to explain the scale problem if both the results are thought to be effective? Thank you very much.
|
|
October 31, 2003, 06:46 |
Re: scale problem
|
#2 |
Guest
Posts: n/a
|
hi,
i believe you can use the Froude number if you want to relate them between each other. The Froude number is commonly used to respect the scale of a model with its physical conditons. Hope this helps David |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |