CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Plot temperature profile (

David October 29, 2003 06:05

Plot temperature profile

does anyone know how to plot a temperature profile during the calculation?

I tried to use the plot command in the execute commands menu but it doesnt work.I know how to display a temperature contours this way but not how to plot it. I believe it should be straightforward, hopefully.

thank you very much for your answer(s)


David October 30, 2003 07:22

Re: Plot temperature profile

noone knows how to plot a temperature profile during calculation in the execute commands menu?

if you know, please inform me


cp October 30, 2003 13:12

Re: Plot temperature profile

The example on Fluent 6.0 Tutorial Chap. 15 (VOF Model) Sec. 7 describes how to plot the variation of 'axial velocity' during iteration. I think, you can use the same logic to get the temperature plot, if you would like to monitor the temperature at a point during simulation.

Hope this helps,


David October 31, 2003 07:30

Re: Injection point
Hi Chendhill,

thank you very much for your help.

However, it gives me a temperature plot in function of time when i want to get a temperature profile evolution during the iterations to see the influence of difference parameters I want to change.

I just found out i have to use animate functions which is very interactive and gives a lot of functions.

Concerning your problem with hollow spray I'm not sure, I have used DPM models but not spray but maybe you have to set your injection points on surface as you might have set it/them on the crown of your injector.

I might use this model later on, so if you didnt find or didn't get a proper answer and i get a clear answer I will let you know.

Hope this helps

thanks again and best regards


ashutosh jaiswal July 24, 2017 05:35

Plot temperature profile
i made a geometry of 2d flow between parallel plates. from graphics and animation i want to draw contour between temperature and total temperature. but it is not showing on the other hand velocity and stream function is showing clearly. can any tell me how i can plot total temperature profile

All times are GMT -4. The time now is 10:12.