 |
 |
 |
|
|
|
[Sponsors] | ||||
Can't figure which cell particle is going to? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 4, 2003, 01:17
|
Can't figure which cell particle is going to?
|
#1 |
|
Guest
Posts: n/a
|
Hi! What does it mean? Should i refine my mesh? Thanks in advance
|
|
|
||
|
November 12, 2003, 19:43
|
Re: Can't figure which cell particle is going to?
|
#2 |
|
Guest
Posts: n/a
|
Unknown error?
|
|
|
|
||
|
November 12, 2003, 19:45
|
Re: Can't figure which cell particle is going to?
|
#3 |
|
Guest
Posts: n/a
|
hhh
|
|
|
|
||
|
November 13, 2003, 04:54
|
Re: Can't figure which cell particle is going to?
|
#4 |
|
Guest
Posts: n/a
|
hi,
what is your question exactly? give as much informations as possible that we can answer regards David |
|
|
|
||
|
November 13, 2003, 07:18
|
Re: Can't figure which cell particle is going to?
|
#5 |
|
Guest
Posts: n/a
|
Hi All!
This error is displayed when the solver reaches dpm tracking. Instead of tracking it puts out this and passes over to cont phase. As dp injection i use pressure swirl injector. Grid is structured one, created by Gambit automatically. How can I handle this? Thanks a lot in advance |
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can't figure which cell particle is going to | rookie | FLUENT | 3 | December 8, 2017 09:07 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| Can't figure which cell particle is going to -- AB | am | FLUENT | 0 | February 21, 2006 18:13 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Linear Mode
