Home > Forums > Software User Forums > ANSYS > FLUENT

A question about gas-solid fluidized bed!

Mark Forums Read

Reply

Search this Thread

November 7, 2003, 07:28	A question about gas-solid fluidized bed!	#1
mactonald Guest Posts: n/a	how to get the pressure fluctuation at some point in a fluidized bed? After setting up a point closed to the bed wall,I define a mixture pressure.But the curve output dosen't fluctuate.whether the time step or grid interval size has some faults? I am so puzzled! Wish for your help. Thanks !

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
restitution coefficient ofr fluidized bed	T.Hariharanath	FLUENT	20	November 20, 2018 15:28
Top boundary condition for fluidized bed	stan	CFX	0	December 11, 2009 16:00
particle volume fraction in fluidized bed	gopinath bandari	CFX	0	October 6, 2006 04:26
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 13:02
Gas pressure question	Dan Moskal	Main CFD Forum	0	October 24, 2002 23:02

All times are GMT -4. The time now is 07:37.