 |
 |
 |
|
|
|
[Sponsors] | ||||
November 12, 2003, 14:12
|
about initial values
|
#1 |
|
Guest
Posts: n/a
|
Dear all, I meet a problem when modeling a turbulent flow through two parallel heated plates: if I set different kinds of initial values (i.e., based on all zones or inlet flow, or...), I will get significantly different results (i.e., average Nusselt number, velocity, etc.), how can that be? And what should I do with it? thanks!
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 12:08 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 12:16 |
| Unknown error | sivakumar | OpenFOAM Pre-Processing | 9 | September 9, 2008 13:53 |
Linear Mode
