|
[Sponsors] |
November 16, 2003, 10:30 |
three species flowing
|
#1 |
Guest
Posts: n/a
|
this is a case: in a air cuboid room has two injection, one injection is oil spay combustion, the other is water spray cooling
when i set this two discrete phase but the temperature is very high (the lowest temperature teach to 700K after 1 second) why? when i set only one oil spray combustion ,the temperature is also very high why? who can tell me the answer, thanks |
|
November 17, 2003, 09:01 |
who give some advice about this case
|
#2 |
Guest
Posts: n/a
|
thanks very much
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to specify surface flux of a species? | ked | FLUENT | 18 | February 15, 2022 15:03 |
Modelling Biomass Combustion via Species Transport | Racheal | FLUENT | 39 | January 8, 2022 07:42 |
Species mass flow inlet | lorenz | FLUENT | 3 | March 15, 2012 07:26 |
Species order fluent | Raddi | FLUENT | 1 | March 13, 2009 00:21 |
mass fraction of species | Ahmed | FLUENT | 0 | April 18, 2007 11:57 |