Home > Forums > Software User Forums > ANSYS > FLUENT

standard error

Mark Forums Read

Reply

Search this Thread

December 8, 2003, 00:37	standard error	#1
Dear Guest Posts: n/a	I'm modeling an inlet flow of IC engine by Fluent 6.0. I always receive an EOF on Stderr when my iteration goes over tem time steps. Anyone used to have a same problem as me please give me some advices. It's killing me now.Regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CGNS Compiling	Diego	Main CFD Forum	17	December 21, 2014 02:40
nonNewtonian viscosity model	mhassani	OpenFOAM Programming & Development	5	January 7, 2013 10:27
error while running paraFoam!	padmanathan	OpenFOAM	9	October 13, 2009 06:17
user subroutine error	CFDUSER	CFX	2	December 9, 2006 07:31
user defined function	cfduser	CFX	0	April 29, 2006 11:58

All times are GMT -4. The time now is 00:31.