 |
 |
 |
|
|
|
[Sponsors] | ||||
December 10, 2003, 14:32
|
How does an interface works?
|
#1 |
|
Guest
Posts: n/a
|
Hi folks,
I am modelling a propeller using the sliding mesh approach. One of the interface of the rotor is a circular face. Another interface of the stator is rectangular face. Would this combination of interfaces works? If yes, how does the rotor interface transfer its values (velocity) as it is rotating to the stator interface? Cheers, Lam |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
| CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 08:22 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |
Linear Mode
