|
[Sponsors] |
December 10, 2003, 13:32 |
How does an interface works?
|
#1 |
Guest
Posts: n/a
|
Hi folks,
I am modelling a propeller using the sliding mesh approach. One of the interface of the rotor is a circular face. Another interface of the stator is rectangular face. Would this combination of interfaces works? If yes, how does the rotor interface transfer its values (velocity) as it is rotating to the stator interface? Cheers, Lam |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |