|
[Sponsors] |
the separated particle temperature in cyclone |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 17, 2003, 09:25 |
the separated particle temperature in cyclone
|
#1 |
Guest
Posts: n/a
|
Dear guys,
I have simulated aerosol system. Amount of inert particle being heated by hot gas stream along rectangular duct. In this simulation I have apply energy equation, and activate particle interaction with continous phase in DPM control panel. My question are: 1. How to display the value of outlet inert particle temperature after being heated? 2. What is the meaning of the change of heat content in particle track report? Is this show the heat transfer from hot gas to inert particle? and could it be checked or confirm by simple calculation q = m. Cp. (Tinlet particle - Toutlet particle)? Since I have Tinlet particle. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DPM problem - wrong particle temperature | Johannes | FLUENT | 1 | December 1, 2014 13:48 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 07:27 |
how to perform temperature gradient on a particle (Thermophoretic Force) | wwt650420 | FLUENT | 3 | March 23, 2011 03:10 |
Eliminating exchange energy between phase in Granular Temperature diff eqn. | cfdbusiness | FLUENT | 0 | February 2, 2010 23:30 |
DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 02:29 |