|
[Sponsors] |
December 30, 2003, 12:03 |
average temperature
|
#1 |
Guest
Posts: n/a
|
I'm working on effect of tube insert in pipe on heat transfer enhancement.I want to know how I can produce the average temperature, velocity and pressure of fluid in any section of pipe. Thank's for your attention.
|
|
December 30, 2003, 18:00 |
Re: average temperature
|
#2 |
Guest
Posts: n/a
|
Take the section and go for area averaged results, check or record the values...You can also find this with some of the interiors in the flow....
While creating BCs in gambit if you specify that at different locations you need to record the vel,pr or temp..., then create them and then look for area averaged values... |
|
January 1, 2004, 00:43 |
Re: average temperature
|
#3 |
Guest
Posts: n/a
|
just create the iso surface of grid, and then go to the report and then click the surface intergrals. in this panel use mass-average or area average of any variable on the created iso surface .
for further help about fluent , u r welcome thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Computing Average Temperature using DEFINE_ADJUST macro | T81 | Fluent UDF and Scheme Programming | 13 | October 16, 2017 06:58 |
Volume Average Temperature | Ashutosh | FLUENT | 1 | February 19, 2017 18:46 |
average interior temperature less than the operating temperature | Naher | FLUENT | 4 | March 31, 2011 23:14 |
Average Temperature vs. Location, Star-CCM+ | new2CFD | Siemens | 6 | March 13, 2008 14:57 |
Temperature Average | Danny | FLUENT | 0 | May 3, 2005 05:47 |