Home > Forums > Software User Forums > ANSYS > FLUENT

reading data into fluent

Mark Forums Read

Reply

Search this Thread

December 28, 2003, 02:31	reading data into fluent	#1
co2 Guest Posts: n/a	Dear Fluent Users, I have collected data for radiation heat flux on a surface. Data is collected for 1 hour intervals. Now I need to run my model over several days and the variation of sun radiation (as depicted by the collected data) must accurately be considered by the fluent model. How Do I read this data into fluent and specify it for the heat flux BC on the surface?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Converting a mesh with splitted cells using fluentMeshToFoam	jlpelerin	OpenFOAM Meshing & Mesh Conversion	4	April 25, 2011 17:56
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic	sponiar	OpenFOAM Meshing & Mesh Conversion	2	March 30, 2009 16:02
Problem of import fluent data to ilight fieldview	seasoul	FLUENT	3	September 9, 2008 23:36
Error reading 3d eccentric annulus in Fluent	Parag Ramteke	FLUENT	0	March 16, 2005 19:46
Fluent data format	khalil	FLUENT	4	May 1, 2002 06:57

All times are GMT -4. The time now is 17:53.