Home > Forums > Software User Forums > ANSYS > FLUENT

Error: floating point exception

Mark Forums Read

Reply

Search this Thread

January 23, 2004, 05:27	Error: floating point exception	#1
Joern Guest Posts: n/a	Dear all, I am using polyflow to simulate an extrusion process and flpost as postprocessor. When I try to view a sweep surface with flpost I get the following error message: Error: floating point exception Did anyone know this problem and can help me? Thanks, Joern

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MPI Error - simpleFoam - Floating Point Exception	scott	OpenFOAM Running, Solving & CFD	3	April 13, 2012 17:34
block-structured mesh for t-junction	Robert@cfd	ANSYS Meshing & Geometry	20	November 11, 2011 05:59
reactingFoam floating point exception	pajofego	OpenFOAM	0	November 6, 2010 18:29
Cannot Open .sim (Floating Point Exception)	trex930	STAR-CCM+	1	July 30, 2010 07:51
[Gmsh] Gmsh and samplesurface	touf	OpenFOAM Meshing & Mesh Conversion	2	December 10, 2007 03:27

All times are GMT -4. The time now is 12:38.