|
[Sponsors] |
February 15, 2004, 00:11 |
any way to dump result in to one file
|
#1 |
Guest
Posts: n/a
|
I am running 40 models with fluent, and what I want to know is the change of the flow rate for these 40 modles. I use script to run these cases with jou files in the background. Finally I saved the cas and data files. since I only care about flowrates. I don't want to read these data files one by one. Can I dump the flowrate in to a file after I finish each case?
thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |
gcc and executable file from Mac to Linux | simone Marras | Main CFD Forum | 0 | April 8, 2007 15:49 |