|
[Sponsors] |
April 28, 2011, 05:22 |
Boundary conditions
|
#1 |
New Member
Philémon
Join Date: Apr 2011
Location: Paris
Posts: 1
Rep Power: 0 |
Hello everyone
I'm working on the combustion in turbofan. I know the mass flows and the pressures in the combustor. Do you know if I should rather use mass flow inlet or pressure inlet? In each case i should get the same results but I don't. Thanks everyone |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
Pressure boundary conditions | Lionel S. | Main CFD Forum | 1 | August 24, 2007 18:03 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |