CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   FLUENT (https://www.cfd-online.com/Forums/fluent/)
-   -   simulation two phase closed thermosyphon (https://www.cfd-online.com/Forums/fluent/33060-simulation-two-phase-closed-thermosyphon.html)

mohammad reza February 19, 2004 05:11

simulation two phase closed thermosyphon
 
i am working on performance of two phase closed thermosyphon.can i use fluent software for simulation of two phase closed thermosyphon? thank you for recoments and guides

ROOZBEH February 21, 2004 07:28

Re: simulation two phase closed thermosyphon
 
Hi; In general you can simulate some multiphase flows of some kinds in Fluent. If your phases make a continuose domain, you should use the multiphase model else, you should use the discrete phase model. I think that for your problem you should use the first option. If the surface tracking of phases is important for you, you should use the multiphase VOF model and...

Hope this help you

ROOZBEH

mohammad reza February 24, 2004 05:33

heat tran simulation two phase closed thermosyphon
 
can you help me for heat transfer simulation condensation/boiling in two phase closed thermosyhon?

ImVKMahato November 1, 2016 04:58

Greetings sir.. I want to simualte a two phase closed thermosyphon.. I have read various jounal papers about it..But I dont know the procedure to set up the simulation. Plz assist.. any help will be very much appreciated..Regards


All times are GMT -4. The time now is 18:51.