|
[Sponsors] |
February 27, 2004, 14:39 |
help on separating zone
|
#1 |
Guest
Posts: n/a
|
hi everyone,
When I separated fluid zone with Grid---> Separate-->Cell--> Adaption-->Region---> Mark---> I got the information which is Separates zone 2 into two zones, with 12499 and 1 cells. Zone not separated. I don't compleately understand what this means. Does that mean that I failed to separate zone? Why it said zone 2 into two zones, with 12499 and 1 cells? Can I see the new zone in the Grid Display? Thanks for your highlighting. Zwdi |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
HELP please!!! ''note: separating wall zone into zones..'' - Import from ICEM | Catthan | FLUENT | 4 | December 13, 2010 13:12 |
Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |
Sliding mesh error | Karl Kevala | FLUENT | 4 | February 21, 2001 15:52 |