 |
 |
 |
|
|
|
[Sponsors] | ||||
March 9, 2004, 12:18
|
Turbulent Y+"enhanced wall treatment"
|
#1 |
|
Guest
Posts: n/a
|
Hi;
If I want to use "enhanced wall treatment" in a wall bounded turbulent flow, can I refine near wall mesh without any limit so that the Y+ is in order of "0.01" ? Thanks |
|
|
||
|
March 9, 2004, 18:01
|
Re: Turbulent Y+"enhanced wall treatment"
|
#2 |
|
Guest
Posts: n/a
|
Usually you should use an y+ close to 1 for the enhancement wall treatment, but a lower value shouldn't be a problem.
Hi  ap |
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thin Wall Heat Transfer BC for rhoSimpleFoam | swahono | OpenFOAM Running, Solving & CFD | 12 | October 4, 2013 11:49 |
| UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 12:03 |
| The Turbulent Wall Jet | chams | Main CFD Forum | 0 | June 3, 2010 09:25 |
| K turbulent kinetic energy patchField type with wall function | sek | OpenFOAM Running, Solving & CFD | 2 | September 13, 2006 16:58 |
| Wall Reaction in Turbulent flow | Rajab | FLUENT | 1 | June 27, 2002 20:34 |
Linear Mode
