|
[Sponsors] |
April 14, 2004, 23:29 |
Transient heat transfer
|
#1 |
Guest
Posts: n/a
|
Dear Friends,
I am relatively new user to FLUENT .I have one problem need your help, I would like to know how i can input the transient heat transfer's intializtion condition? I cannot fully understand what the manual introduce. If anybody have the expericenes, please share with me Sorry for troubling u,but I hope u will not mind it. thanks and regards Regards, Jane |
|
April 15, 2004, 12:22 |
Re: Transient heat transfer
|
#2 |
Guest
Posts: n/a
|
Unless you have a trivial initial condition (i.e., constant tempertaure and velocity, etc.), you would need to read in the data file (*.dat) from a steady-state analysis that corresponds to your initial condition.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heat transfer (conduction) between two pipes | shields | FLUENT | 14 | February 3, 2016 07:45 |
help on a convective heat transfer transient model | cmbv | FLUENT | 0 | December 14, 2007 17:16 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Transient heat transfer | Jonas | FLUENT | 3 | October 18, 2003 01:57 |
time steps in transient heat transfer in solids | Mike | Main CFD Forum | 3 | June 5, 2003 05:47 |