CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

3D species transport model - 1

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   April 21, 2004, 15:44
Default 3D species transport model - 1
  #1
co2
Guest
 
Posts: n/a
A cylindrical tank contains grain at the bottom. Grain is modeled as porous zone Tank walls are thin but are modeled as solid zone for sun radiation calculations (Heat source terms are specified in the tank walls to account for sun radiation) Grain liberates co2 gas due to grain respiration Heat is also liberated during grain respiration and has been incorporated in the engery source term in porous zone pannel I am using mixture template consisting of co2 + O2 + N2 There are no reactions involved I am using species model

question: When I run my 3D unsteady model with air as fluid I get good convergence, but the moment I switch to mixture template, my continuity residual does not go below 0.001 ----- Does anyone know why this is happening? I am sure that I have a very good mesh with 120000 cells (all hex) --- I am surprised and disappointed that I am facing this roadblock in solution to my problem -- PLEASE HELP ..

  Reply With Quote

Old   April 23, 2004, 05:20
Default Re: 3D species transport model - 1
  #2
emre
Guest
 
Posts: n/a
Hi,

I had a similar problem 3D, spe4, all hex mesh and heat xfer. I started with no species as you did. Also I ran the cold flow solution. Later on I activated species transport equations and then energy equation, (for incomp. ideal gas). Also the under-relaxtion factors were all 0.1-0.2 less than the defaults. BTW, my model did not have any porous media which may make the convergence harder.

Hope this helps Regards
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
questions about species transport through walls shuqin FLUENT 13 April 9, 2014 03:42
Divergence problem for species transport model MY FLUENT 3 January 11, 2014 05:46
species transport model or mixture model? achaokaoyan Main CFD Forum 0 July 10, 2010 11:52
species transport in water lyn FLUENT 1 December 12, 2007 19:15
Can Fluent handle species transport in multi-phase Roger FLUENT 1 January 30, 2003 20:12


All times are GMT -4. The time now is 05:27.