 |
 |
 |
|
|
|
[Sponsors] | ||||
April 23, 2004, 23:36
|
iteration problem
|
#1 |
|
Guest
Posts: n/a
|
hello everybody:
during the iteration of the eddy dissipation model, a message always occure "temphy2:too many iterations at T=0.00000K" what's the reason of it and how to solve this problem??? i have used this model to simulate other cases just with different injecting velocity,and it runs well. thanks sisilxp |
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 01:54 |
| a problem of nozzle simulation | xck1986 | OpenFOAM | 11 | November 27, 2012 08:22 |
| Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
| The problem of inner iteration when calling the subroutine | guoxj | CFX | 18 | October 23, 2010 20:37 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Linear Mode
