CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   modeling roughness (

john May 6, 2004 10:05

modeling roughness
Hi all,

I'm doing an analysis on the effect of surface roughness on transition from laminar to turbulent flow past a spheroid body. When I run the same simulation with or without roughness hight of 1000,400,100,50 micron it seems I don't get any change of the results (pressure distribution, shearing stress etc).

further more the cells near the solid walls were higher than the roughness hight as requested in fluent user guide (Cs=0.5). I use a standard k-omega model for transitional flows.

Thanks in advance john

optixxx May 6, 2004 12:00

Re: modeling roughness

Laminar flow you have no influence of roughness

y=64/RE is remember


All times are GMT -4. The time now is 17:17.