Home > Forums > Software User Forums > ANSYS > FLUENT

definition about specified flux for UDS

Mark Forums Read

Reply

Search this Thread

June 11, 2004, 15:05	definition about specified flux for UDS	#1
zhou Guest Posts: n/a	I defined a UDS (user defined scalar). When i set boundray condition for this UDS at wall, i found there are two options: one is "specified value", another is "specified flux". My quesion is what is definition for this "specified flux". Does it means the gradient of this UDS like d(UDS)/dx or something else? Thanks.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
Problem setting with chtmultiregionFoam	Antonin	OpenFOAM	10	April 24, 2012 09:50
OpenFOAM static build on Cray XT5	asaijo	OpenFOAM Installation	9	April 6, 2011 12:21
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
Definition of Mass flux F1	Gavin	Siemens	1	April 17, 2006 17:51

All times are GMT -4. The time now is 18:36.