Mesh
Hi all,
i am a new cfd user, i want to know is there any "rule of thumb" for fine grid generation. Sometimes i do not know how fine should i do for the mesh/grid in order to give gd accuracy. Can anyone give me some advice? Thank all |
Re: Mesh
Okie there is grid independence condition. The fineness of the grid depends on hit and trial attempts in the sense for instance u have carried the simualtions for say 100 cells but if u do the same set of clacualtions for 200 cells then u will see a change in ur solution since it might hae not yet been gird indpendent. so u have to keep doing till u see that even if u change the grig 10000 u get the same solution. In practical situations to do so u must have good computational capbilities and at the same time in mutliphase flows it is difficult to attain. I hope it helps! Podila
|
All times are GMT -4. The time now is 00:19. |