|
[Sponsors] |
June 26, 2004, 05:05 |
TOPOGRAPHICAL MESH
|
#1 |
Guest
Posts: n/a
|
Dear friends,
I am still in the course of my research program and am hoping that you can help me once again. I am about to survey the river that i hope to model in fluent and the result of this will be a large number of coordinates (x, y, z) giving a basis for a topograhical model of the river bed. I will then be able to generate nodes a edges from these using the MATLAB program and this will result in an ASCII file. My question then: is there any way that I would be able to read this file straight into gambit or fluent so that I do not have the tedious task of connecting the nodes and edges by hand. In the same way, once the nodes and edges have been created, is there a method for automatically defining the faces so that this need not be done manually. any advice you can give would be a great help. thank you nial |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |