 |
 |
 |
|
|
|
[Sponsors] | ||||
July 22, 2004, 09:59
|
Exporting ICEM Mesh into Fluent...
|
#1 |
|
Guest
Posts: n/a
|
Hi People!
I've been told that an ICEM mesh can be exported into Fluent. What is the procedure please? I tried this a couple of times, and I can't get this to work. Or do I need to export the mesh into GAMBIT first and then into Fluent? Any advice folks? Cheers! Regards, Harmeet. |
|
|
||
|
July 28, 2004, 02:56
|
Re: Exporting ICEM Mesh into Fluent...
|
#2 |
|
Guest
Posts: n/a
|
Yes you can export the mesh to Fluent. Use ICEM 5.0 and choose the FLUENT_V6 export Filter. Problems only occur if ICEM 4.3 and the FLuent V5 filter is used.
F.K. |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problems with export 2D mesh from ICEM to FLUENT | newcomer | ANSYS Meshing & Geometry | 54 | September 20, 2014 12:40 |
| GENERATE MESH IN ICEM and OPEN IN FLUENT 12 | Galileo | FLUENT | 10 | September 6, 2013 13:26 |
| Export 2D mesh from ICEM to Fluent | BuilttoSpill | ANSYS Meshing & Geometry | 4 | August 28, 2010 08:16 |
| Import ICEM Mesh to Fluent | Fluent Beginner | FLUENT | 5 | June 23, 2004 00:27 |
| Problems with exporting Gambit mesh to Fluent | Alex Mozharov | FLUENT | 4 | November 24, 2002 01:17 |
Linear Mode
